Sous vide snack sticks
-
kyle I’m not PapaSop but I will weigh in that I have used a unit very similar to the Weston on sale and for home use it has worked great for 2 yrs
Also I highly recommend adapting an insulated cooler for your processing vessel
I cut a snug fitting hole in the lid of a Coleman 20 can party stacker and am very happy with itglen I’d like to see a picture of that if it’s not too much trouble. Thanks
-
kyle I vacuum bag but many here swear by "naked " Which I haven’t tried
I generally remove the product after short a heavy smoke then use the graduated step up heat method in the sous vide.
Also remember the direct heat conductivity of souse vide heats the internals relatively quickly and in my humble opinion at temps higher than 160 you can quickly over heat the product if not careful.
Monitor internals with your thermometer.
Don’t be intimidated, it’s much easier to learn than smokingThere are souse vide diameter/heat/time/pasteurization charts on line that are very helpful.
Kind of hard to find and it just occurred to me to print them out next time I need them LOLglen I was asking for a picture of the cooler setup you use.
-
thanks to all for your input.
-
I used a PVC slip connector to make the hole solid and glued it in with expanding foam
The black marks are from the drawing used to saw the hole, learned later they were permanent!
If you are lucky you may find a hole saw the right size for yoursGive a man a fish and he eats for a day
Teach a man to fish and he drinks beer for a lifetime -
I used a PVC slip connector to make the hole solid and glued it in with expanding foam
The black marks are from the drawing used to saw the hole, learned later they were permanent!
If you are lucky you may find a hole saw the right size for yoursglen
That is perfect. I got to do it now too. -
-
Inside is 11"x8.5"x 13.5" deep
It holds the heat so well I could have gone bigger but it is just the right size for my needsGive a man a fish and he eats for a day
Teach a man to fish and he drinks beer for a lifetime -
Inside is 11"x8.5"x 13.5" deep
It holds the heat so well I could have gone bigger but it is just the right size for my needsglen Thanks for the pictures. I see this in near future. Awesome
-
I used a PVC slip connector to make the hole solid and glued it in with expanding foam
The black marks are from the drawing used to saw the hole, learned later they were permanent!
If you are lucky you may find a hole saw the right size for yoursglen
Great idea. -
Jonathon thanks. So the one you have on sale for $75, would that be a good place to start, or would I be better off with the more expensive one? I hate to spend a lot on something I don’t understand. I did go back and watch your videos on this again. I know PapaSop started doing this. what one does he have?
kyle
A couple pics. May have some more if I can find them. -
I use a electric roaster works great get my water to 160-165 while meat is in the smoker pull it when it’s 140° into the water no vac bags I do everything that way now saves so much time I can get 12# snack sticks or 4 summer sausage logs 2.9x20
-
smokinbubba do you lose any flavor in the water? For some reason in my mind, I think how you boil other things to make stock
kyle no difference in flavor or texture. Seemed to be less dry which was expected
-
Also, I run an elcheapo yissvic unit from Amazon and use a 40qt plastic storage tote for a vessel. Took a while to get up to 175 but was worth the wait!! Easily held 7 2.5x24 logs of trail.
-
Thanks everyone. Cooler idea is great
-
kyle I vacuum bag but many here swear by "naked " Which I haven’t tried
I generally remove the product after short a heavy smoke then use the graduated step up heat method in the sous vide.
Also remember the direct heat conductivity of souse vide heats the internals relatively quickly and in my humble opinion at temps higher than 160 you can quickly over heat the product if not careful.
Monitor internals with your thermometer.
Don’t be intimidated, it’s much easier to learn than smokingThere are souse vide diameter/heat/time/pasteurization charts on line that are very helpful.
Kind of hard to find and it just occurred to me to print them out next time I need them LOLglen
Can you please explain, What is your “graduated step up heat method in the sous vide?”.I vac sealed my sticks in 21 CM casing and set sous vide to 155 for 2 hours. Then ice bathed. Appreciate if you could explain your process using the sous Vide.
Also, can you point me to the charts you referenced below…
“There are souse vide diameter/heat/time/pasteurization charts on line that are very helpful”.Thank you!
-
glen
Can you please explain, What is your “graduated step up heat method in the sous vide?”.I vac sealed my sticks in 21 CM casing and set sous vide to 155 for 2 hours. Then ice bathed. Appreciate if you could explain your process using the sous Vide.
Also, can you point me to the charts you referenced below…
“There are souse vide diameter/heat/time/pasteurization charts on line that are very helpful”.Thank you!
burgetdk If I am smoking the sticks I usually give them about 1/2 hr at 110 with vents wide open to dry, then heavy smoke at 120F for an hour, then SV at 135F for 1/2 hr. increase to 150 - 155F in SV for around 45 min, then Ice bath, then air drying. I should note I use cure #1 in my sticks.
In other words I basically use the same product temp graduation as the smoker schedule just much shorter times are needed and because of the temperature transfer speed I don’t need the higher temps associated with finishing in the smoker.
If I don’t want smoke in my product I use the same schedule starting at 110F totally in SVThis chart when used in the context of the whole article (especially the paragraph below the chart) is a great guide
https://stefangourmet.com/2018/04/01/how-to-choose-time-and-temperature-to-cook-meat-sous-vide/The next article with charts explains the time/temp lethality explaining you don’t necessarily need to go to 160F to be safe
https://www.food-safety.com/articles/4722-the-danger-zone-reevaluatedSome will never fell safe not taking temps to 160 and that is fine, do what you are comfortable with
For instance I do not want to eat pink pork even it is OK now -
burgetdk If I am smoking the sticks I usually give them about 1/2 hr at 110 with vents wide open to dry, then heavy smoke at 120F for an hour, then SV at 135F for 1/2 hr. increase to 150 - 155F in SV for around 45 min, then Ice bath, then air drying. I should note I use cure #1 in my sticks.
In other words I basically use the same product temp graduation as the smoker schedule just much shorter times are needed and because of the temperature transfer speed I don’t need the higher temps associated with finishing in the smoker.
If I don’t want smoke in my product I use the same schedule starting at 110F totally in SVThis chart when used in the context of the whole article (especially the paragraph below the chart) is a great guide
https://stefangourmet.com/2018/04/01/how-to-choose-time-and-temperature-to-cook-meat-sous-vide/The next article with charts explains the time/temp lethality explaining you don’t necessarily need to go to 160F to be safe
https://www.food-safety.com/articles/4722-the-danger-zone-reevaluatedSome will never fell safe not taking temps to 160 and that is fine, do what you are comfortable with
For instance I do not want to eat pink pork even it is OK now
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginSponsored By:
