Pk100.

[jbird]

My pk100. Temp is off by 100 degrees. Is it the temperature wire or is it the temperature control box. If it is the wire where is it ?

[smoke king]

You will find the temp probe behind the tin plate at the back of the smoker what I would do first is pull the controller out and check for loose wires also how are you checking to find that it is off temp the temp will vary a lot in different areas.

[jbird]

Well if I set the temp at 130. It go to 230. Ave checked the temp all over the smoker. It just climbs out of control.

[lkrfletcher]

Bill Rink
Account Executive
PS Seasoning
Pro-Smoker & Roaster
800-328-8313
920-370-1684 cell
563-359-7967 Hm Office
billpsseasoning@aol.com

[smoke king]

jbird do you have the instructions for the controller if not if you want give me your email and I will send you a copy do you have a ohm meter you should see 1000 ohms at 25 °C on the probe.

[jbird]

Yep I do have a the instructions for the TS2 TEMP DIGITAL CONTROLLER. I got a new one that them. And I new temp probe I see how they put the probe wiring in now. So it. The probe should read. 1000 ohms at 25 c. ?

[jbird]

Thanks for the help. Temp probe is good. Tested as ohm as the new one. The controller was shot.

[smoke king]

Your welcome I’ve been using the pk 100 for more then 9 years had to replace the controller and the probe the probe is no fun it’s run down on the inside of the frame.

[processhead]

Are you able to get the probes and control boards replaced under warranty? If not, how much are the replacement parts costing you?

[jbird]

No. Warranty it’s 3 years old. Controller is 140$ and the probe is $18. I ordered them right from pro smoker.