Mushy snack sticks
-
dh4ever77 hello before I dive in I am gonna ask how many pounds is your total meat block? There are a few things I am gonna suggest. #1 is get rid of the carrot fiber, as others have suggested sure gel is the way to go but honestly I started out not using any binder and they came out very well. I do use sure gel now but unfortunately it is backordered. You can mix small batches by hand and get good protein extraction with or without a binder. Your water is actually below what I use, which is approximately 2.5 ounces per pound so too much water is not your issue.
On the pk100 I am familiar with but have not used, I have the bigger brother to the pk100. Which the only difference is it has two burners and a circulation fan for even cabinet heat and drying capabilities. Your cook cycle will take longer as well. With your pk100 use only the 1250watt setting. Here is the smoke/cook cycle I am suggesting.
Heat up smoker to 250* or highest setting
Add sausage and TURN HEAT DOWN TO 110*
110* for 1 hour dampers wide open (drying stage)
125* for 2 hours damper 1/2 open bottom 1/8th open top if you have one (start smoke)
140* for 1 hour (smoke)
155* for 2 hours (remove smoke pan after first hour of this cycle)
170* until IT is 160* with all dampers closed.
Smoke is optional you can do more, less or none at all based on your liking.Next is my meat block, I will share for a 25lb batch and you can divide it up to get a per pound ratio
16.50 lbs lean protein (beef or venison)
6.50 lbs 80/20 pork trim
2.00 lbs pork back fat
1800 ml of ice cold distilled water
1 oz sure cure (that is dissolved in the water)
1 package sure gel (.375 lbs)
Seasoning of choiceMake sure all meat is super cold but not frozen during entire process. You can grind partially frozen if you have a big enough grinder to handle it. I wear cotton gloves with nitrile gloves over top while mixing.
twilliams that is a great post thanks for sharing such detailed information
-
Jamieson22 i mixed in a hand held mixer from lem was like laffy taffy so sticky. The sticks were very wet they do not snap,but the casings stay intact. I also stuck my mini i grill in multiple till 160. I even double checked them with my kicken prob. I found some excalibur sure gell received it to day will be trying it again this weekend. I always used it then tryed carrot fiber and drew a blank till everyone pointed that out. Thank you for the response.
dh4ever77 Do you by chance have a dehydrator? Be curious what a few hours in there would do for these.
-
dh4ever77 Do you by chance have a dehydrator? Be curious what a few hours in there would do for these.
Jamieson22 I do not it was a pk100 or nice dehydrator. I went with the pk. I got some rump roast and pork but. I will be trying it again today. Then hold and smoke tomorrow. Everyone loves the flavor and they seem a bit firmer after a week in fridge. I have the rest vacuum sealed and frozen.
-
dh4ever77 hello before I dive in I am gonna ask how many pounds is your total meat block? There are a few things I am gonna suggest. #1 is get rid of the carrot fiber, as others have suggested sure gel is the way to go but honestly I started out not using any binder and they came out very well. I do use sure gel now but unfortunately it is backordered. You can mix small batches by hand and get good protein extraction with or without a binder. Your water is actually below what I use, which is approximately 2.5 ounces per pound so too much water is not your issue.
On the pk100 I am familiar with but have not used, I have the bigger brother to the pk100. Which the only difference is it has two burners and a circulation fan for even cabinet heat and drying capabilities. Your cook cycle will take longer as well. With your pk100 use only the 1250watt setting. Here is the smoke/cook cycle I am suggesting.
Heat up smoker to 250* or highest setting
Add sausage and TURN HEAT DOWN TO 110*
110* for 1 hour dampers wide open (drying stage)
125* for 2 hours damper 1/2 open bottom 1/8th open top if you have one (start smoke)
140* for 1 hour (smoke)
155* for 2 hours (remove smoke pan after first hour of this cycle)
170* until IT is 160* with all dampers closed.
Smoke is optional you can do more, less or none at all based on your liking.Next is my meat block, I will share for a 25lb batch and you can divide it up to get a per pound ratio
16.50 lbs lean protein (beef or venison)
6.50 lbs 80/20 pork trim
2.00 lbs pork back fat
1800 ml of ice cold distilled water
1 oz sure cure (that is dissolved in the water)
1 package sure gel (.375 lbs)
Seasoning of choiceMake sure all meat is super cold but not frozen during entire process. You can grind partially frozen if you have a big enough grinder to handle it. I wear cotton gloves with nitrile gloves over top while mixing.
-
Jamieson22 I do not it was a pk100 or nice dehydrator. I went with the pk. I got some rump roast and pork but. I will be trying it again today. Then hold and smoke tomorrow. Everyone loves the flavor and they seem a bit firmer after a week in fridge. I have the rest vacuum sealed and frozen.
dh4ever77 said in Mushy snack sticks:
Jamieson22 I do not it was a pk100 or nice dehydrator. I went with the pk. I got some rump roast and pork but. I will be trying it again today. Then hold and smoke tomorrow. Everyone loves the flavor and they seem a bit firmer after a week in fridge. I have the rest vacuum sealed and frozen.
Maybe see if you can dry a small batch out in your oven?
-
dh4ever77 it was actually a whole hog I had trimmed up in 25lb batches at 80/20 ratio. I was buying 2 Berkshire hogs a year from my hog supplier. I would have one butchered for family meals of steaks, roasts and bacon, the other just all pork trim for sausages and fresh brats for the year. Pork butts is an option if that is all you can get but I doubt you would get a 80/20 ratio. You would have to trim all fat off the lean then weigh each lean and fat separately to figure out what your ratio is.
-
dh4ever77 it was actually a whole hog I had trimmed up in 25lb batches at 80/20 ratio. I was buying 2 Berkshire hogs a year from my hog supplier. I would have one butchered for family meals of steaks, roasts and bacon, the other just all pork trim for sausages and fresh brats for the year. Pork butts is an option if that is all you can get but I doubt you would get a 80/20 ratio. You would have to trim all fat off the lean then weigh each lean and fat separately to figure out what your ratio is.
-
dh4ever77 it was actually a whole hog I had trimmed up in 25lb batches at 80/20 ratio. I was buying 2 Berkshire hogs a year from my hog supplier. I would have one butchered for family meals of steaks, roasts and bacon, the other just all pork trim for sausages and fresh brats for the year. Pork butts is an option if that is all you can get but I doubt you would get a 80/20 ratio. You would have to trim all fat off the lean then weigh each lean and fat separately to figure out what your ratio is.
-
twilliams well i guess my question is i have a 6lb beef roast. Should i mix with the pork shoulder and back fat or just back fat?
dh4ever77 I prefer pork added to my meat block. It’s not a must. So for a 6 lb lean beef meat 30% of that is 1.8 pounds. So if you do 6 lb lean beef, 1.8 lbs 80/20 pork trim and .2 lbs of pork fat giving you an even 8 lb meat block would be close to a 70/30 mix. Or you could do 6 lb lean beef with 1.5 lbs of pork fat and no pork trim for a total of 7.5 lb meat block.
-
Everyone has given great advice, but I will add this little caveat. I do not add liquid according to recipes, but according to the mince’s appearance. There are just too many variables in meats today, some inject phosphates, some saline water, and others it is just meat, so when I am mixing I add liquid to the point where the mince has a nice shiny glossy appearance, no more or no less and it has never failed me, ever. If you are wondering what that looks like, just add a little liquid at a time when mixing and you will see the mince turn from a dull paste looking glob to a pretty mince that shines, that is the perfect mince.
-
While feeding I also was thinking and I do not know how the recipes are developed for pre-packaged seasonings, but most all professional sausage makers use green hams and back fat to specific ratios, if you are like me and use what is available or on sale then that can also throw off the moisture content and texture of your mince. Not the end of the world, but something to think about when adding liquid.
-
Hello my snack sticks and summer sausage keep coming out very soft and mushy. Any pointers would be greatly appreciated. Thank you
Im using all waltons products and pk100 smoker. I am using the 1lb and 5lb conversion charts for the amount of meat i have. Im putting 1/2 cup of carrot fiber binder per 5lbs and 2oz of water per lb of meat. Im doing 80/20 with pork back fat and lean beef. And folllowing the smoke schedule from the how-to page. I have a 20lb mixer and 5lb sausage stuffer. The meat comes out of the stuffer very sticky. I am totally lost. They used to come out perfect now this winter has been a struggle. Would to much carrot fiber and water be the reason? I noticed on the 25lb batch seems like less carrot fiber and water compared to the 1 and 5 lb conversion chart.
dh4ever77 If everything is the same as the recipe goes, then the only other variable is you are not stuffing tight enough and that will cause a mushy stick for sure.
-
Everyone has given great advice, but I will add this little caveat. I do not add liquid according to recipes, but according to the mince’s appearance. There are just too many variables in meats today, some inject phosphates, some saline water, and others it is just meat, so when I am mixing I add liquid to the point where the mince has a nice shiny glossy appearance, no more or no less and it has never failed me, ever. If you are wondering what that looks like, just add a little liquid at a time when mixing and you will see the mince turn from a dull paste looking glob to a pretty mince that shines, that is the perfect mince.
-
dh4ever77 If everything is the same as the recipe goes, then the only other variable is you are not stuffing tight enough and that will cause a mushy stick for sure.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginSponsored By:
