Base diameter of Waltons 13MM stuffing tube.

[chippewa]

I have a 15 # Hakka stuffer and want to use the 13mm Waltons tube to make 19mm snack sticks. The Hakka tube has a 2” OD at the base and just wanted to make sure the Waltons one was the same size.

[twilliams]

chippewa see if you can find someone with this tube and see if they can take a dial calipers and measure the outside diameter. Mine is 12.7mm and the 19mm casings barely fit on it. I need to cut the full length into thirds in order to put them on.

[chippewa]

I have standard dial calipers Trying to find the best balance of stuff ability and fitting on the tube. My Hakka tubes are way to small and just to big.

[mrobisr]

I have the Walton’s 11# stuffer and all the tubes bases are the same diameter and measured 2".

[chippewa]

mrobisr thank you so much. I placed the order for it.

[Jamieson22]

chippewa I have Hakka 15# and the 13mm tube works well with it. I mainly do 21mm stick using it.

[Dave in AZ]

mrobisr can you confirm these are 2", and not 2-1/8? That is, 51mm and not 53? I have a Meat! Stuffer with 51mm bases, they supply no stainless tubes, and I haven’t found any actual 2in. I had to buy the 53mm and grind down to fit… would LOVE to find actual 2in base tubes!
Thx

[mrobisr]

Dave in AZ Sorry my caliper died and have another one ordered, but until then here is a pic with tape measure.

[Dave in AZ]

mrobisr sweet, thx! Great to know, I need to get some stainless tubes on order for all sizes.

[mrobisr]

Dave in AZ

[mrobisr]

Dave in AZ Sorry I misled you, but as you can see they are indeed 53mm.

[Dave in AZ]

mrobisr no worries, I have 3 or 4 on order for the sizes I need, that had a nice solid base f l a n g e wide enough for me to grind.
Went with 10mm for 16 to 18mm casings
12mm for 19mm casings,
12.7mm i.e 0.5in for 21mm casings,
and 19mm I think. Maybe 1 is a real 2in base, rest will be ground.