11 lb sausage stuffer
-
Thanks for the input guys! Is it not an airtight seal so you can back out the plunger and then push air forcing the remaining meat out?
I do like a patty though and saving it for eggs or pizza a good idea too!Elsos no the meat won’t back out if you crank the handle backwards it stays in the elbow of the stuffer and usually the horn whatever size horn you have on
-
Elsos no the meat won’t back out if you crank the handle backwards it stays in the elbow of the stuffer and usually the horn whatever size horn you have on
-
So I’ve never used a stuffer other than that grinder attachment for the mixer, and my jerky gun (overzealous calking gun).
I need to up my game for sure!How much meat stays in the 90* bend at the bottom of the stuffers? Is that basically full and can’t be pushed into a sausage?
Thanks in advance for any replies.Elsos my pile of junk stuffer leaves about 1 1/2 pounds of meat at the bottom that i have to put in tubes by hand. Not a Waltons stuffer
-
I got a Jerky cannon that will take a stuffing tube and load it with the leftovers. And stuff into a casing. You only end up with a little bit left in the stuffing tube. Fry it up for a treat.
mdseaside yep, I’m only using a cannon for snack sticks, really a pain having to reload it after each pound!
I’ve done a couple rounds of sausage with the grinder attachment which wasn’t the end of the world, but it seems like that’s really not the way.
Seems to me that having a horizontal stuffer would be a huge benefit, I wish Walton’s sold them. -
Elsos With the 11 lb it is about 12 oz or so. Now, that depends on how much water and other additives are added to the meat but it has always been about the size of a good chunky burger.
-
Here is what i did with my vertical stuffer. It came with a long thumb screw that held the stuffing piston to the long rod, so i replaced it with a bolt and then shimmed the piston down with large SS flat washers and gained a good half inch. Just make sure the piston does not bottom out. Cut down on the leftovers by about 1/2.
-
Yes, make sure the piston doesnt bottom out, that can ruin your gearbox. But aside from that, that is a pretty cool modification mdseaside
-
Here is what i did with my vertical stuffer. It came with a long thumb screw that held the stuffing piston to the long rod, so i replaced it with a bolt and then shimmed the piston down with large SS flat washers and gained a good half inch. Just make sure the piston does not bottom out. Cut down on the leftovers by about 1/2.
mdseaside : I did the same, works well
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginSponsored By:
