Thanks Jonathon and JoeB, it was [probably both of what you all suggested. For sure something happened with the bind since fat came out and after the final 3rd grind it did seem to look more fatty than I was expected. It was the first time I used pork fat alone with venison. I’ll use pork butt next time. The mixer is small and although it did seem to end up as a sticky paste when completed, I do stop it occasionally and pull the meat off the paddle because it does look like it gets wound around the paddle axel without at lot of mixing action. How critical is meat temperature during the grinding/mixing process to keep the bind? I had read elsewhere that the hot dog meat temperature needs to stay below 40 degrees the whole time for the emulsification to not break. Is that true? Would seem difficult to accomplish in the home setting.

Jonathan - made first batch of hot dogs, 3.5 lbs venison, 1.5 lbs pork fat; used the above recipe for 5lbs, no cheese, and no smoked meat stabilizer (kept overnight in refrigerator then smoked the next day using the above schedule). Noticed there was a little solidified fat between the hot dogs and celluose casing but it wasn’t a lot. Tasted more like a brat than a hot dog but it was the consistency that was most un-hot dog like. It was softer and not as rubbery/flexible as a hot dog. I did use a meat mixer (about 10 min) and it was very tacky when completed and added about 6 oz of water. Any idea of what I did wrong or how to make them a better consistency. Too much fat? Mixed for too long? Thanks.