Venison Hot Dog Issue
-
slyoder Hanging them is fairly easy to do, your XXL should have come with a smoke stick that you can use to hang them. We don’t close, crimp or tie off the endings when we hang. You might get some bulbing at the open ends but it should be a very small amount if you got proper protein extraction.
-
I have found that fat out is caused by 2 things mostly. Not enough protein extraction or not stepping up temp SLOOOWLY when thermal processing. I think you had plenty of PE but you really need to find a way to step up your TP very slowly. I start at 125deg for 30-45min then go to 135,145,155,165,175 until internal temp is 160. Never go above 180’F or you risk fat out. I have been skipping the smoker altogether and sous viding my bambi dogs and bambi bologna. Add recommended ammt of hickory powder and put them in naked (the dogs that is) ice water bath and strip celulose. I make a good bit of bambi dogs and bologna. To me, the smoker puts a “rind” on the outside of by bambi dogs that I dont care for.
Oh, 30% pork fat minimum. Fat is flavor! and the venison needs it.If the women don’t find you handsome, they should at least find you handy - Red Green
-
I have found that fat out is caused by 2 things mostly. Not enough protein extraction or not stepping up temp SLOOOWLY when thermal processing. I think you had plenty of PE but you really need to find a way to step up your TP very slowly. I start at 125deg for 30-45min then go to 135,145,155,165,175 until internal temp is 160. Never go above 180’F or you risk fat out. I have been skipping the smoker altogether and sous viding my bambi dogs and bambi bologna. Add recommended ammt of hickory powder and put them in naked (the dogs that is) ice water bath and strip celulose. I make a good bit of bambi dogs and bologna. To me, the smoker puts a “rind” on the outside of by bambi dogs that I dont care for.
Oh, 30% pork fat minimum. Fat is flavor! and the venison needs it.smokinbubba sounds like a good method.
-
Hey guys! I believe this is the first time I have posted. I made 27 pounds of venison hot dogs this past weekend and am not pleased with the result. I’m sure you guys will be able to tell me what went wrong, so here is what I did.
I followed the Bearded Butchers recipe from YouTube. I used 22 (due to the amount in the bags selected) pounds of clean venison and 5 pounds of pork fat. I mixed in 12 ounces of Bearded Butchers Original Seasoning, 4 ounces of Hickory Smoke powder, 4 ounces of minced garlic directly to the meat prior to the first grind. Ground it a total of 5 times through my Waltons #32: first time through 3/8" plate, 2nd - 5th through 1/8" plate. I added 2.5 pounds of ice in the mix for grind #5. Grinder handled it awesome. Moved it to the 50# mixer attached to the #32 grinder. Added 1 ounce of sure cure (Waltons) and 16 ounces of water. Mixed it for 4 minutes, added another 16 ounces of water, mixed for additional 4 minutes (total 8 minutes of mixing). Loaded up the Waltons 11 pound stuffer and stuffed Waltons cellose 26mm hot dog casings. European -style linked. Refrigerated for about 20 hours. Cooking was done with the Traeger Ironwood 885. First 2 hours at 165 degrees. Then, 1 hour at 185, then turned it up to 205 and cooked to internal temperature of 165. Pull them out at 165, placed them immediately into an ice bath for 1 hour. Pulled them out and dried them off.
The issue is… it looks like most of the fat came to the outside of the meat and the dogs seem kind of dry (even though you can see the meat is moist) and the texture is grainy.
Where did I go wrong and what is the solution?
Thanks in advance.
-
I have found that fat out is caused by 2 things mostly. Not enough protein extraction or not stepping up temp SLOOOWLY when thermal processing. I think you had plenty of PE but you really need to find a way to step up your TP very slowly. I start at 125deg for 30-45min then go to 135,145,155,165,175 until internal temp is 160. Never go above 180’F or you risk fat out. I have been skipping the smoker altogether and sous viding my bambi dogs and bambi bologna. Add recommended ammt of hickory powder and put them in naked (the dogs that is) ice water bath and strip celulose. I make a good bit of bambi dogs and bologna. To me, the smoker puts a “rind” on the outside of by bambi dogs that I dont care for.
Oh, 30% pork fat minimum. Fat is flavor! and the venison needs it.smokinbubba said in Venison Hot Dog Issue:
I have found that fat out is caused by 2 things mostly. Not enough protein extraction or not stepping up temp SLOOOWLY when thermal processing. > Oh, 30% pork fat minimum. Fat is flavor! and the venison needs it.
Regarding fat out, I would add that another significant contributor is too high of temperatures due to inaccurate thermal control or processing sausages in smokers intended for hot smoking and simply can’t be set for lower temperatures.
Sausage is much less tolerant to overtemperatures than ribs, brisket, or a pork butt. If you are going to process sausage on a high temp smoker, you better be watching closely and have a good thermometer to monitor internal temperatures.
Having a known, accurate thermometer to check against the internal probes on a smoker is essential, IMO.
My $.02 worth.
-
I made a latch for the door of my propane smoker. I can keep it around 100 degrees with the door open about an inch
-
Hey guys! I believe this is the first time I have posted. I made 27 pounds of venison hot dogs this past weekend and am not pleased with the result. I’m sure you guys will be able to tell me what went wrong, so here is what I did.
I followed the Bearded Butchers recipe from YouTube. I used 22 (due to the amount in the bags selected) pounds of clean venison and 5 pounds of pork fat. I mixed in 12 ounces of Bearded Butchers Original Seasoning, 4 ounces of Hickory Smoke powder, 4 ounces of minced garlic directly to the meat prior to the first grind. Ground it a total of 5 times through my Waltons #32: first time through 3/8" plate, 2nd - 5th through 1/8" plate. I added 2.5 pounds of ice in the mix for grind #5. Grinder handled it awesome. Moved it to the 50# mixer attached to the #32 grinder. Added 1 ounce of sure cure (Waltons) and 16 ounces of water. Mixed it for 4 minutes, added another 16 ounces of water, mixed for additional 4 minutes (total 8 minutes of mixing). Loaded up the Waltons 11 pound stuffer and stuffed Waltons cellose 26mm hot dog casings. European -style linked. Refrigerated for about 20 hours. Cooking was done with the Traeger Ironwood 885. First 2 hours at 165 degrees. Then, 1 hour at 185, then turned it up to 205 and cooked to internal temperature of 165. Pull them out at 165, placed them immediately into an ice bath for 1 hour. Pulled them out and dried them off.
The issue is… it looks like most of the fat came to the outside of the meat and the dogs seem kind of dry (even though you can see the meat is moist) and the texture is grainy.
Where did I go wrong and what is the solution?
Thanks in advance.
ToddDSheppard What kind of fat did you use? Suet will render out at a lower temperature then regular fat. I personally use much more fat I’m my hotdogs, closer to 40%. Either way it’s possible it got too warm during the process.
-
Got to be pure white pork goodness for dogs. accept no substitute.
DWB, I like your 40%. I bet Oscar uses more than that!
If the women don’t find you handsome, they should at least find you handy - Red Green
-
Got to be pure white pork goodness for dogs. accept no substitute.
DWB, I like your 40%. I bet Oscar uses more than that!
smokinbubba said in Venison Hot Dog Issue:
Got to be pure white pork goodness for dogs. accept no substitute.
DWB, I like your 40%. I bet Oscar uses more than that!
The USDA regs doesn’t allow more than 30% fat in commercial hot dogs.
-
Got to be pure white pork goodness for dogs. accept no substitute.
DWB, I like your 40%. I bet Oscar uses more than that!
smokinbubba It was the pure white pork goodness that I used. Question for you, though. Do you step up the temperature when you are sous viding the bambi dogs? If so, what is your schedule?
-
I did the same thing you didn’t mix it enough to mix the fat it should be a slurry when you are done 8 min mix not enough.
-
smokinbubba It was the pure white pork goodness that I used. Question for you, though. Do you step up the temperature when you are sous viding the bambi dogs? If so, what is your schedule?
ToddDSheppard I do ramp up the temp in the Sv. I start at 125,135,145,155,165,175. Prolly over kill but once u have a fat out u get real cautious!
-
ToddDSheppard I do ramp up the temp in the Sv. I start at 125,135,145,155,165,175. Prolly over kill but once u have a fat out u get real cautious!
smokinbubba Thank you, Sir. I completely agree with getting real cautious. But, with this information I will be running another batch very soon.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginSponsored By:
