How To Make Snack Sticks
-
We use a 50lb meat mixer and mix it pretty well. It is definitely sticky and is a bit of a chore to stuff with our 15lb stuffer. I am guessing we mix (crank by hand) for 10-15 minutes or so.
I am using an electric smoker and have tried ramping up the temp and that took forever to finish a batch of sticks. So, I have been just running at 150 for an hour and then 200 degrees until the sticks hit 160 degrees and it takes about 8 hours per batch.
Gregg - Fargo, ND
Smokin-It #3 Electric Smoker that replaced a Masterbuilt XL, Big Chief (still used for fish), and few others over the years, along with a variety of Weber Gas/Charcoal Grills, Anova Sous Vide, etc. devices. -
We use a 50lb meat mixer and mix it pretty well. It is definitely sticky and is a bit of a chore to stuff with our 15lb stuffer. I am guessing we mix (crank by hand) for 10-15 minutes or so.
I am using an electric smoker and have tried ramping up the temp and that took forever to finish a batch of sticks. So, I have been just running at 150 for an hour and then 200 degrees until the sticks hit 160 degrees and it takes about 8 hours per batch.
NDKoze
Sounds like your mixing is good, and it is most likely just your cooling cycle then.Next time you do them, if you have any problems, let us know, but it sounds like a better cooling cycle will fix your problem.
-
How To Make Snack Sticks
Our latest how-to video for Meatgistics is about How To Make Snack Sticks.
Watch the full video below, read the highlights here, and then post your comments or questions below.Share your input and questions
Join in on the conversation about making snack sticks! What is your favorite flavor? Do you prefer beef, pork, wild game or chicken? Is there anything you need help or input from others in perfecting your process?
What Makes a Snack Stick
A snack stick is a meat snack stuffed into a small diameter casing, typically with a low pH from around 4.5 to 5.2 which provides that familiar tangy flavor, plus it helps aid in shelf stability. Another aid to shelf stability is a low water activity which means binding water in the product to make it unavailable to support microbial growth. This is not something that can really be measured by a home meat processor, but we still setup our process and thermal processing to attempt to achieve a lower water activity. Snack sticks can be made from beef, pork, chicken, wild game, or a combination of meats. We typically recommend using a lean to fat ratio of 80/20, but up to 30 or 40% fat is still just fine and the extra fat will mean more flavor.
Ingredients
25 lb 80/20 beef trim
1 package Excalibur Buffalo Bleu Cheese Snack Stick Seasoning
1 oz Sure Cure
6 oz Sure Gel Binder
2 quarts ice water
4 oz Encapsulated Citric Acid
2 to 3 lb of high temp cheese
19mm Collagen CasingsMeat Grinding
Start the initial grind with a 3/8" grinder plate, then grind a second time through a 1/8" grinder plate. Always use a sharp grinder knife and plate. This will help you retain a better particle definition, color, and help prevent any smearing of the meat. If you cannot easily distinguish the lean from the fat when grinding, then it may be time for a new grinder plate and knife.
Meat Mixing
Using a meat mixer is preferred to hand mixing when making snack sticks. We need to make sure we get a lot of protein extraction, and that is a bit more difficult to achieve in hand mixing but still a possibility to do if you don’t have an actual meat mixer. We are going to want to mix for about 8 minutes, and we’ll want to reverse the direction of the mixing paddles every 1 minute. When you start the mixer, just start adding all the ingredients, except the Encapsulated Citric Acid and High Temp Cheese. These last two ingredients can be added in the last 45-60 seconds of the cycle, or just long enough to evenly disperse. Over mixing Encapsulated Citric Acid could lead to breaking the encapsulate and over mixing the cheese can lead to smearing and loss of shape.
Stuffing
Avoid creating air pockets when you load your sausage stuffer and begin stuffing until the casings are full with a smooth exterior. We will stuff into as long of ropes as we can, and then we’ll cut them to length when we actually hang on smoke sticks in the smokehouse.
Thermal Processing
Either hang on smoke sticks or lay on racks in your smokehouse or oven. Just be sure to leave a slight gap between the snack sticks. A simple cooking schedule you can follow is here:
125F for 1 hour
140F for 1 hour
155F for 2 hours
175F until internal meat temp of 160FCooling
To help set the casing to the meat and also prevent wrinkling we need to shower the snack sticks when they are done cooking or put them in an ice water bath. It should only take around 10 minutes to get the temperature to drop down. Then, we’ll let them set out for about 1 hour before moving to the refrigerator/freezer. After we are totally done with the cooling process, then we will package in vacuum pouches for longer term storage.
Wrap up
It’s easy to get the basics on making snack sticks, but practice does make perfect. Walton’s has everything you need (except the meat) to make great snack sticks, plus we have the knowledge to help you perfect your own process. If you have any questions or need help in your process, please share your questions or comments below.
Meatgistics: How To Make Snack Sticks
-
Austin this is not anything I have ever tried because I don’t have all the adapters for my grinder
stimy28 said in How To Make Snack Sticks:
Austin this is not anything I have ever tried because I don’t have all the adapters for my grinder
Stuffing tubes for a grinder are not too expensive. If you don’t have a sausage stuffer and want to try stuffing off your grinder sometime, take a look at these here: https://www.waltonsinc.com/parts/grinders-parts/stuffing-horns
If you give it a shot and have any questions, let us know if we can help!
-
rumbbq said in How To Make Snack Sticks:
how do you get temp so low in the smoker or do i need a special one
Maintaining a low temp is going to be very dependent upon what smokehouse you have. Just start as low as yours can reach.
The smokehouse we cooked in was a commercial smokehouse (see this post) so we definitely have a few more options than most.If I’m cooking at home, my smoker only goes down to 150, so I’d just start at 150 and stay there for the first several hours, until I was ready to bump up to 175 or higher. Many small smokers and smokehouses can get lower, even to 100 or less, so it just depends on your Brand/Make/Model.
For a somewhat inexpensive model, you can get from 100 to 275 on a Cajun Injector Electric Smoker
Or a higher end model like a PK100 Smokehouse, temps can be as low as 60 (as long as your ambient temp isn’t higher) and up to 250What kind of smoker do you have?
-
rumbbq said in How To Make Snack Sticks:
how do you get temp so low in the smoker or do i need a special one
Maintaining a low temp is going to be very dependent upon what smokehouse you have. Just start as low as yours can reach.
The smokehouse we cooked in was a commercial smokehouse (see this post) so we definitely have a few more options than most.If I’m cooking at home, my smoker only goes down to 150, so I’d just start at 150 and stay there for the first several hours, until I was ready to bump up to 175 or higher. Many small smokers and smokehouses can get lower, even to 100 or less, so it just depends on your Brand/Make/Model.
For a somewhat inexpensive model, you can get from 100 to 275 on a Cajun Injector Electric Smoker
Or a higher end model like a PK100 Smokehouse, temps can be as low as 60 (as long as your ambient temp isn’t higher) and up to 250What kind of smoker do you have?
-
We don’t use any sure gel or citric acid our sticks always turn out good . We have a 12 mm horn on our hydraulic stuffer and it doesn’t want to push the meat through. How much water can I ad to 25 pounds without having to much shrinkage in the casings?
-
We don’t use any sure gel or citric acid our sticks always turn out good . We have a 12 mm horn on our hydraulic stuffer and it doesn’t want to push the meat through. How much water can I ad to 25 pounds without having to much shrinkage in the casings?
MatthewHolzer Both of those ingredients are optional. There are various reasons to use them or not use them, but we recommend using them.
It’s always going to be slow and difficult pushing meat through such a small stuffing tube, unless you’ve got a vacuum stuffer. What brand/model of stuffer do you have? I would only recommend using up to 2 quarts of water per 25 lb of meat. I couldn’t tell you how well it would work using any more. You might also look at the lean to fat ratio in your meat as well. Extremely lean meat will difficult to stuff as well, and adding some more fat could help.
-
From my experience too much water allows shrinkage, overheating smokehouse will cook out the fat-if you have a pool of fat in the bottom of your smoker it’s too hot. I made wood sticks to hang meat from out of hickory i keep them right on the sticks, ice bath or spray with hose and cold water-benefit of living in the northeast…Total smoker time is about 4-5 hours, i like a good smoke. Also put the sticks in the smoker for 15-45 until they are dry before adding smoke, it you try it while they are wet the smoke bonds to the water and runs off, looks terrible but still edible.
-
MatthewHolzer Both of those ingredients are optional. There are various reasons to use them or not use them, but we recommend using them.
It’s always going to be slow and difficult pushing meat through such a small stuffing tube, unless you’ve got a vacuum stuffer. What brand/model of stuffer do you have? I would only recommend using up to 2 quarts of water per 25 lb of meat. I couldn’t tell you how well it would work using any more. You might also look at the lean to fat ratio in your meat as well. Extremely lean meat will difficult to stuff as well, and adding some more fat could help.
Austin we have a mainca em20 hydraulic stuffer. We use half deer and half pork in our spicy sticks. We always mix our meat strips with the cure and seasoning and a little water then double grind.
-
Austin we have a mainca em20 hydraulic stuffer. We use half deer and half pork in our spicy sticks. We always mix our meat strips with the cure and seasoning and a little water then double grind.
MatthewHolzer
When we got our hydraulic stuffer I had the same issue. They were never meant to push through that small of a tube. I talked to a butcher supply company and he explained to me if you are using casings smaller than 32mm you WILL blow the motor out. We have a 1hp and he is it’s not if but when the motor goes if we continue to do 17mm casings. So i stepped up to the 21mm casings, i fine grind one time both pork and venison and add about 1qt of water to 20# of meat. It has helped but still a slow go and still trip the breaker on the motor a couple times when we do 100 pound runs. I mix the spice and water into a slurry using a wisk, that also helps. -
Austin we have a mainca em20 hydraulic stuffer. We use half deer and half pork in our spicy sticks. We always mix our meat strips with the cure and seasoning and a little water then double grind.
MatthewHolzer Parksider
I cannot speak for the quality or abilities on a Mainca or other brands, but…
We sell and recommend Talsa Stuffers. We have one here in our test kitchen as well. They do not have a problem running snack sticks on a 12mm horn. 10mm can get to be a little more difficult but can work fine still. A 12mm horn works fine for us and stuffing then into 19mm collagen casings.Even on the smallest Talsa we offer, at a 26lb capacity and 1.75HP, they will stuff snack sticks fine. I think a lot of the capability just relies on what brand and quality of motor is in the hydraulic stuffer.
If you are doing half deer and half pork, the deer is going to be very lean so just make sure the pork used has a high enough fat content. You can safely use up to about 40% of the total product weight in fat and water (approximately 2 quarts water and meat at 75/25 lean to fat ratio), but that’s the limit I’d suggest. If you still struggle to stuff snack sticks at that point, it may just be a limitation on the stuffer you are using.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginSponsored By:
