Grinder Plates

Reply to Grinder Plates on Fri, 04 Jan 2019 15:15:24 GMT

Parksider — Fri, 04 Jan 2019 15:15:24 GMT

thegunnut I’d also get a knife and keep the knife and plate together so they wear together. Walton’s has Speco plates and knives that can be resharpened over time, I’d say they are worth the extra $, if not they are just disposable.

Reply to Grinder Plates on Fri, 04 Jan 2019 00:00:11 GMT

lamurscrappy — Fri, 04 Jan 2019 00:00:11 GMT

Jonathon is absolutly right. My other advice would be to make sure and buy one with a hub. Makes it much easier to pull out.

Reply to Grinder Plates on Sat, 29 Dec 2018 03:05:16 GMT

Emoneyblue — Sat, 29 Dec 2018 03:05:16 GMT

Most do fit… Just order a #12 plate and it will fit!

Reply to Grinder Plates on Wed, 26 Dec 2018 21:52:18 GMT

Jonathon — Wed, 26 Dec 2018 21:52:18 GMT

thegunnut Not all plates are universal but in general, you can use one for another. The main thing to pay attention to is the way the plate locks into the grinder. Most plates will have either 1 or 3 notches cut out of the plate around its circumference, this is how it locks into the head. 3 notch plates will work with grinders that have 1 or 3 locking tabs, 1 notch plates will not work with 3 tab grinders.

Other than that they should mostly all fit each other, diameter and even thickness is pretty standard, as is the center hole diameter. If you buy a cheap model from another country the plates might be hard to match but with something like a cabellas model you should be good!