<![CDATA[Jerky Blaster Trick]]>Well not so much of a trick, its just my way of getting that last bit of meat out of the nozzle when using my Cabela’s Jerky Blaster (FYI best gun I’ve used) Anyway once your down to your last 1/2 tube of meat, open the tube from the opposite side of the nozzle, take 2 slices of bread and roll them up, put those in the open end of your tube, re assemble the gun and finish the job. At the end it helps clean out the tube and only leaves you with that tiny bit of meat, flatten it out and add to your rack. Hope it helps out.
0_1532885287251_20180729_115610-1.jpg 0_1532885311371_20180729_115637-1.jpg 0_1532885337891_20180729_115453-1.jpg 0_1532885358446_20180729_115424-1.jpg 0_1532885394626_20180729_115516-1.jpg

]]>https://waltonsdev.nodebb.com/topic/649/jerky-blaster-trickRSS for NodeFri, 11 Sep 2026 01:04:07 GMTSun, 29 Jul 2018 17:32:27 GMT60<![CDATA[Reply to Jerky Blaster Trick on Mon, 30 Jul 2018 16:32:45 GMT]]>Jonathon Hey Jonathan thanks! That little plug is hard as a rock when it comes out lol, I’m sure the bread would work for your aplication as well, also the dog loves it.

]]>https://waltonsdev.nodebb.com/post/1837https://waltonsdev.nodebb.com/post/1837Mon, 30 Jul 2018 16:32:45 GMT<![CDATA[Reply to Jerky Blaster Trick on Mon, 30 Jul 2018 14:28:11 GMT]]>I do this with my grinder to get the last little bit of meat out, I’ve seen it work with the stuffer also but you need to use 4 slices of bread.

]]>https://waltonsdev.nodebb.com/post/1834https://waltonsdev.nodebb.com/post/1834Mon, 30 Jul 2018 14:28:11 GMT<![CDATA[Reply to Jerky Blaster Trick on Mon, 30 Jul 2018 12:37:12 GMT]]>Gary T I had to upvote this post because that’s genius! I wonder how dense the bread becomes and if I could use this on a stuffer to get the rest out my snack stick or summer sausage out of the tube, that always annoys me. I don’t so much mind what’s in the bottom of the cannister as I make a patty out of it but whats in the tube always goes to waste.

Thank you for the tip!

]]>https://waltonsdev.nodebb.com/post/1833https://waltonsdev.nodebb.com/post/1833Mon, 30 Jul 2018 12:37:12 GMT